Differences

This shows you the differences between two versions of the page.

--- programs:fertilizer_programs [2023/02/24 07:42] – marilisebester_gmail.com
+++ programs:fertilizer_programs [2023/03/01 09:15] (current) – [Adding a Fertilizer Program to a Step] marilisebester_gmail.com
@@ Line 109: / Line 109: @@
 ====Fertilizer Pump Alarms====
-H: “Fert Pump Start Delay (sec)” – Enter the pump start delay here
+  * H: “Fert Pump Start Delay (sec)” – Enter the pump start delay here
-I: “Fert Pump Alarm Sensor” – Select the relevant sensor from the dropdown list
+  * I: “Fert Pump Alarm Sensor” – Select the relevant sensor from the dropdown list
-J: “Fert Pump Alarm Min” – Enter the min value allowed for sensor selected
+  * J: “Fert Pump Alarm Min” – Enter the min value allowed for sensor selected
-K: “Fert Pump Alarm Max” – Enter the max value allowed for sensor selected
+  * K: “Fert Pump Alarm Max” – Enter the max value allowed for sensor selected
+=====Output Control=====
+{{ :programs:output_control.png?nolink&400|}}
+  * A: “Max Catchup (%)” –
+  * B: “Output Rate Control”
+    *  	“Always On” – used during batching, keeps the dosing valve open
+    *  	“Analog VSD Output” –
+    *  	“Duty Cycle” – used during proportional dosing, opens & closed the dosing valves based on values entered in C – E
+    *  	“Pulse Frequency” –
+    *  	“On/Off Delay” – used during proportional dosing, opens & closed the dosing valves based on values entered in C - E
+  * C: “Min Injector Off Delay (sec)” –
+  * D: “Min Injector On Delay (sec)” –
+  * E: “Control Cycle Duration (sec)” –
+======Adding Fertilizer to Valve Program======
+=====Adding a Fertilizer Program to a Step=====
+Each “Step” has provision to add Fert Programs.
+{{ :programs:fert_to_step.png?nolink&400 |}}
+  * A: To add a Fertilizer program to the Valve Program, click on the “+”
+{{ :programs:fert_step_details.png?nolink&400 |}}
+  * As seen above, you can now enter the following specifications:
+    * "Liters" - if dosing according to a batching method
+    * "L/m3" - if dosing according to a proportional method
+    * "EC" - if dosing to maintain a certain EC
+    * "Pre-Delay" - duration of time that must pass from start of irrigation until fert program starts
+    * "Post-Delay" - duration of time that the fert program must stop before the irrigation program stops