Differences

This shows you the differences between two versions of the page.

--- programs:fertilizer_programs [2023/03/01 09:08] – marilisebester_gmail.com
+++ programs:fertilizer_programs [2026/04/09 07:25] (current) – marilisebester_gmail.com
@@ Line 97: / Line 97: @@
 ====Fertilizer Flow Rate Alarms====
+Daar is 3 soorte alarms
+AlarmFertilzierUncontrolled   Fert valve is closed but we are still reading fertlizler flow
+.AlarmFertilzierNoFlow  Fert valve is open but we are NOT reading any fertlizler flow
+.Flowrate alarm the dosing rate l/h cannot be controlled withing % error This will only work if you are using fast soloinds and your choke valves is properly  tuned to say 50 to 80%  output if you cannot maintain this disable the alarm
   * A: “Alarm on Low Tank Level” – Tick to enable alarm on Low Tank Level
   * B: “Enable Fertilizer Flow Rate Alarm” – Tick to enable Flow Rate Alarm set on Fertilizer
@@ Line 127: / Line 134: @@
   * E: “Control Cycle Duration (sec)” –
-=====Adding Fertilizer to Valve Program=====
+======Adding Fertilizer to Valve Program======
-====Adding a Fertilizer Program to a Step====
+=====Adding a Fertilizer Program to a Step=====
 Each “Step” has provision to add Fert Programs.
+{{ :programs:fert_to_step.png?nolink&400 |}}
   * A: To add a Fertilizer program to the Valve Program, click on the “+”
+{{ :programs:fert_step_details.png?nolink&400 |}}
-{{ :programs:fert_to_step.png?nolink&400 |}}
+  * As seen above, you can now enter the following specifications:
+    * "Liters" - if dosing according to a batching method
+    * "L/m3" - if dosing according to a proportional method
+    * "EC" - if dosing to maintain a certain EC
+    * "Pre-Delay" - duration of time that must pass from start of irrigation until fert program starts
+    * "Post-Delay" - duration of time that the fert program must stop before the irrigation program stops