Differences

This shows you the differences between two versions of the page.

--- programs:filter_programs [2023/03/06 07:51] – [Using an external flush controller] marilisebester_gmail.com
+++ programs:filter_programs [2023/03/08 06:23] (current) – marilisebester_gmail.com
@@ Line 2: / Line 2: @@
 Please note that to create a filter program, the following must be created first:
-  * "Filter" Mainline
+  * "Filter" Mainline - created under setup_mainlines
-  * Valves for each of the backflush valves on the filter station
+  * Valves for each of the backflush valves on the filter station - created under setup_manage valves
-  * DP (Differential Pressure) sensor
+  * DP (Differential Pressure) sensor - created under setup_all sensors
+Should you require help in creating these, please contact your Farmsync Technician
-There are two scenarios that will be explained below:
+=====Creating a Filter Program=====
-  - Creating a Filter Program where flushing is managed by an external flush controller
-    - In this case, Farmsync only sends a start & end command
-  - Creating a Filter Program that issues all commands from Farmsync
-    - In this case all the flush times are set on Farmsync
-=====Using an external flush controller=====
 {{ :programs:program_details1.png?nolink&400 |}}
   * A: “Name” – Enter a name for the Filter Program
@@ Line 18: / Line 13: @@
   * C: “Station” – Select the relevant station that the filter is connected to from the dropdown list
+Press "Save" in order to set the rest of the settings for this program
 {{ :programs:program_details2.png?nolink&400 |}}
@@ Line 37: / Line 33: @@
   * M: “Filter Start Delay (seconds)” – Duration of time allowed to pass after filter program has started before filter flushes
-See below example of flush program explained:
+See below example of flush program times explained:
+{{ :programs:1flush_timing.png?nolink&600 |}}
 {{ :programs:flush_timing.png?nolink&600 |}}
+{{ :programs:program_details3.png?nolink&400 |}}
+  * A: “Flush Activated Sensor” –
+  * B: “Flush Active Port” –
+  * C: “Before Filter or Differential Pressure Sensor” – Select the relevant Pressure Sensor / DP Sensor from the dropdown list
+  * D: “After Filter Pressure Sensor” – Select the relevant Pressure Sensor from the dropdown list (if DP Sensor was selected in C, then this sensor can be left to "Not Set"
+  * E: “Remote Flush Program to Start when Flushing” –
+  * F: “Remote Pause / Resume program when flushing” – Select the relevant program that must be paused if the flushing sequence is initiated, this program will resume once the flushing program is completed
+  * G: “Mainline Control Valve” – Select the relevant Mainline Control Valve from the dropdown list, should one be present
+  * H: “Mainline Control Valve Close Delay” – Enter the duration of time allowed to pass from when filter flush is initiated before the Mainline Control Valve must close
+  * I: “Master Filter Program” – Select the relevant Filter program from the dropdown list
+  * J: “Auto Start from Master Filter Program” – Enable if current filter program must start the same time as the Master Filter Program
+=====Flush Valves=====
+{{ :programs:flush_valves.png?nolink&400 |}}
+Choose from the dropdown lists below the relevant Flush Valves that were created for the Filter under “Setup_Manage Valves”; Provision has been made for 32 valves in total.