Differences

This shows you the differences between two versions of the page.

--- programs:filter_programs [2023/03/08 06:11] – marilisebester_gmail.com
+++ programs:filter_programs [2023/03/08 06:23] (current) – marilisebester_gmail.com
@@ Line 2: / Line 2: @@
 Please note that to create a filter program, the following must be created first:
-  * "Filter" Mainline
+  * "Filter" Mainline - created under setup_mainlines
-  * Valves for each of the backflush valves on the filter station
+  * Valves for each of the backflush valves on the filter station - created under setup_manage valves
-  * DP (Differential Pressure) sensor
+  * DP (Differential Pressure) sensor - created under setup_all sensors
+Should you require help in creating these, please contact your Farmsync Technician
-There are two scenarios that will be explained below:
+=====Creating a Filter Program=====
-  - Creating a Filter Program where flushing is managed by an external flush controller
-    - In this case, Farmsync only sends a start & end command
-  - Creating a Filter Program that issues all commands from Farmsync
-    - In this case all the flush times are set on Farmsync
-=====Using an external flush controller=====
 {{ :programs:program_details1.png?nolink&400 |}}
   * A: “Name” – Enter a name for the Filter Program
@@ Line 18: / Line 13: @@
   * C: “Station” – Select the relevant station that the filter is connected to from the dropdown list
+Press "Save" in order to set the rest of the settings for this program
 {{ :programs:program_details2.png?nolink&400 |}}
@@ Line 53: / Line 49: @@
   * J: “Auto Start from Master Filter Program” – Enable if current filter program must start the same time as the Master Filter Program
+=====Flush Valves=====
+{{ :programs:flush_valves.png?nolink&400 |}}
+Choose from the dropdown lists below the relevant Flush Valves that were created for the Filter under “Setup_Manage Valves”; Provision has been made for 32 valves in total.